新闻

What are the reasons for the failure of the compression garbage truck?

2021-08-29 08:40:26
Second
Author:翊成网络z

Compression garbage trucks are beautiful in appearance, excellent in performance, and advanced in control and control. They adopt after-loading compression and two-way compression technology to complete the collection of urban domestic garbage, and their comprehensive performance has reached the advanced level of similar domestic products. It is mainly suitable for the collection and transportation of barreled, bagged and bulk domestic garbage in urban residential areas, communities, large factories and mines, and government institutions. Multiple bucket turning (bucket) mechanisms, suitable for multiple garbage collection methods for different users.


No matter how sophisticated the design is, there will always be failures. Sometimes it may be caused by improper operation by the user, or due to aging parts. The following are the common failure causes and solutions of the compression garbage truck summarized by the compression garbage truck supplier :



Fault 1. Engine oil leaks.

Solution: repair or replace the leaking parts.

Fault 2. Crankcase ventilation pipe is blocked.

Solution: Check whether the crankcase ventilation device is good.

Trouble 3. The valve stem and valve guide are worn out.

Solution: Check the gap between the valve stem and the guide tube, and replace with a new one if necessary.

Fault 4. The valve stem oil seal is worn or damaged.

Solution: Check the wear of the valve stem oil seal and replace it if necessary.

Trouble 5. The piston ring was installed reversely during maintenance, causing the oil to escape into the combustion chamber.

Solution: Install the piston ring correctly.

Fault 6. The piston ring is stuck in the ring groove due to glue or the piston is worn out.

Solution: Check the wear degree of the piston ring and whether it can rotate freely in the ring groove.

Fault 7. The lubricating oil is selected improperly and the viscosity is too small.

Solution: Choose lubricating oil according to factory requirements.

Fault 8. Too much lubricating oil has been added.

Solution: Add lubricating oil according to the standard.


label

0
Copyright © Yangzhou Jinwei Environmental Protection Technolog All rights reserved Record No: SU ICP No. 2021019778-1 苏公网安备32100302011074 technical support:YichengNetwork
  • home
  • telephone
  • Back